The MotoTech Hydration Reservoir 2L Water Bladder is made from BPA-free material and features an easy-to-fill slide opening mechanism.
Features -
Capacity: 2L
Lightweight and low-profile
Quick Connector TPU Tube with Neoprene Cover for Temperature Control
Shape-Retention Centre Baffle increases stability during high-impact activities
TPU Bladder / Reservoir - Made with BPA-Free, Recyclable, Anti-bacterial
90 Degree Bite Valve with Quick Tube Connector
Fully reversible bladder – For easy cleaning & drying
Ultra-durable RF welded seams for superior durability and elasticity
Wide working temperature range (-20° deg C to +50° deg C)
Slide Opening Mechanism for quick filling and closes tight for a leakproof seal
Convenient to carry handle providing a secure grip
The Bite Valve is designed to Self-seal after each sip
Smooth twist on/off switch to prevent leaks when not in use
Dust cap to keep bite valve clean of dust and grime
A flexible 100 cm long TPU tube provides a steady flow of water
Dimensions: 370mm x 160mm
Mototech Hydration Bladder (2L)
OPTION 1
- Per liter volume of your hydration system, add ¼ Cup of baking soda to ¾ Cup of water and shake for 30 seconds (e.g., for a 2L hydration system use ½ Cup of baking soda with 1 ½ Cup water)
- Add ¼ Cup lemon juice per liter, close, and shake for 10 seconds, then vent by opening the hydration system away from the face
- Re-seal the hydration system and repeat shaking and venting three times. Expel as much air as possible, close the hydration system, and soak for 20 minutes
- Dump the solution and rinse the hydration system three times with warm water.
OPTION 2- Add 3 spoons of lemon juice, pour water about 3/4 part, and Close the Bladder
- Shake it well and keep it in the freezer for about 8 hours
- Pour out the water after defrosting
- Clean the Hydration Reservoir and you are good to go👍
Note: The above solution (in appropriate proportion) can also be used to easily clean the pipe at the same time.
How to Dry the Hydration Reservoir?
In general, it is optimal to prop or hang hydration system reservoirs upright to dry—this allows moisture to evaporate and escape upward.
Drying the Hydration Reservoir is easy. First, wipe the interior with a dry towel (made easy thanks to the large opening!). Then prop the reservoir open with the Slider and let it all air dry.